I collected buttons from different family members which made
each ornament a special family keepsake.
Materials:
2 inch styrofoam ball
About 50 gold tone buttons of different sizes and
patterns
18" long half inch wide ribbon
Craft wire
Straight pin
6" thin gold cord
Gold spray paint
Hot glue gun
Toothpicks
Directions:
• Stick about six toothpicks all around the Styrofoam ball so it can stand
up at different angles.
• Lightly spray paint the ball gold completely
covering it. If the paint is too heavy it may dissolve
the styrofoam. As you turn the ball to paint all sides don't let it sit in
paint. Make sure it is up on
toothpicks. Let it dry according to the paint
directions then remove the toothpicks.
• With a glue gun, glue buttons to painted ball
pushing the stem of the button into the ball. Cover
the ball with buttons except for the small spot on top where you attach the
bow.
• Tie a small knot in the gold cord making a hoop to hang the ornament.
Stick a straight pin through the knot. Put a some hot glue on the pin and
insert it into the top bare spot.
• Make a bow for the top using ribbon and craft wire. Make repeated hoops
securing with wire as you go. Glue the bow to the bare spot and you are done!
